Akai X-200 D

Data[edit]

General

Connections

Number of inputs: 3
- Microphone: 0.5 mV, 50 kOhm
- Phono: 50mV, 150 kOhm
- Radio: 50mV, 150 kOhm
- Din: 5 - 50mV, 150 kOhm
Number of outputs: 3
- Line: 1.23 V
- Din: 400 mV
- Headphone: 30mV, 8 Ohm

Technical Data

1x hysteresis synchronous capstan motor

- 2x winding motors, external rotor
Heads: 3
Tracks: 4
Tape speeds:
- 4.75 cm/s
- 9.5 cm/s
- 19 cm/s
- 38 cm/s with adapter
Synchronization fluctuations:
- < 0.20% RMS (4.75 cm/s)
- < 0.12% RMS (9.5 cm/s)
- < 0.08% RMS (19 cm/s)
Pitch fluctuations:
Overall frequency response:
- 40Hz-9kHz ±3 dB (4.75 cm/s).
- 40Hz-19kHz ±3 dB (9.5 cm/s)
- 40Hz-23kHz ±3 dB (19 cm/s)
Signal-to-noise ratio: > 58 dB
Signal-to-noise ratio:
Total harmonic distortion: < 1.8% (1 kHz)
Entzerrung: nach NARTB
Übersprechdämpfung:
- Mono: >65 dB

Stereo: > 45 dB

Special Features

Crossfield audio head system: In the Crossfield audio head system, the so-called bias magnetization of the audio tape is not - as is generally the case - via the recording/playback head, but via a separate audio head (bias head) located opposite the aforementioned recording/playback head. This pickup head arrangement allows signal modulation over the entire audio frequency spectrum without any interference from bias magnetization as is the case with other pickup head systems.
Autoreverse
Magnetic brakes
Switchable equalization
Auto stop and auto power off
Vertical and horizontal operation possible
Variable DIN adjustment
Tape type selector switch
Autoreverse with continuous operation
Slider for level adjustment
26cm tapes can be used with additional module EA-11