Difference between revisions of "Denon DRA-75 VR"
(→Links) |
(→Bemerkungen) |
||
Line 75: | Line 75: | ||
== Bemerkungen == | == Bemerkungen == | ||
+ | AV receiver | ||
+ | <Power amplifier part> | ||
+ | Output power (20Hz - 20kHz) 65W+65W (8ohms) | ||
+ | Practical use maximum except take-off (EIAJ) 95W+95W (8ohms) | ||
+ | 110W+110W (6ohms) | ||
+ | Input sensitivity/impedance CD input: 150mV(a maximum of 10V) /47kohm | ||
+ | THD 0.0095% (20Hz - 20kHz, 32.5W, 8ohm) | ||
+ | Cross modulation distortion 0.025% (an equivalent for 65W, 8ohms) | ||
+ | Dynamic power 175W (2ohms) | ||
+ | Output bandwidth 5Hz - 40kHz (Output 32.5W, 0.05%, 8ohms) | ||
+ | Line-in frequency response 20Hz-50kHz±1.5dB (1W, 8ohm) | ||
+ | Output load impedance 0.1ohm or less | ||
+ | Output terminal Speaker: AorB:6-16ohm, A+B:12-16ohm | ||
+ | Headset-jack maximum except take-off: 80mW (8ohms), 8-400-ohm conformity | ||
+ | <Preamplifier part> | ||
+ | Input sensitivity/impedance Phono MM: 2.5mV/47kohm | ||
+ | Phono MC: 0.25mV/100 ohms | ||
+ | CD, AUX, Video/Tape1, VCR/Tape2(PB):150mV /, 47kohm | ||
+ | The maximum except take-off/Output power 10V/150mV (Rec Out, Processor Loop Out) | ||
+ | RIAA deflection 20Hz-20kHz±0.5dB (MM IN-Rec Out & Processor Loop Out) | ||
+ | Signal to noise ratio | ||
+ | (an input short circuit, the auditory sensation weighting A) Phono MM: 82dB (at the time of a 2.5mV input) | ||
+ | Phono MC: 62dB (at the time of a 0.25mV input) | ||
+ | Line: 98dB (at the time of a 150mV input) | ||
+ | Tone control characteristic Bass: ±8dB (100Hz) | ||
+ | Treble: ±8dB (10kHz) | ||
+ | Loudness characteristic | ||
+ | (A continuation variable, maximum) 50Hz:+10dB | ||
+ | 10kHz:+5dB | ||
+ | <Image part> | ||
+ | Terminal Video-In, VCR-In/Out, Monitor-Out | ||
+ | Rated voltage/impedance 1 Vp-p/75ohms (input and output) | ||
+ | <FM tuner part> | ||
+ | Received frequency 76MHz - 90MHz | ||
+ | Intermediate frequency 10.7MHz | ||
+ | Antenna terminal 300ohms of coaxial 75ohm& terminal type balance | ||
+ | Practical speed 9.3dBf | ||
+ | Signal to noise ratio sensitivity of 50dB stereo:36.5dBf | ||
+ | mono:13.5dBf | ||
+ | The degree of effective selection 60dB (±400kHz) | ||
+ | Capture ratio 1.2dB | ||
+ | IF disturbance ratio 70dB | ||
+ | Image disturbance ratio 40dB | ||
+ | AM oppression ratio 60dB | ||
+ | Frequency response 20Hz-15kHz+0.2 -0.5 dB | ||
+ | Auditory-sensation-weighting signal to noise ratio mono:82dB | ||
+ | stereo:80dB | ||
+ | THD (1kHz) mono:0.07% | ||
+ | stereo:0.12% | ||
+ | Degree of separation 48dB(1kHz) | ||
+ | <AM tuner part> | ||
+ | Received frequency 522kHz - 1629kHz | ||
+ | Intermediate frequency 450kHz | ||
+ | Antenna terminal Terminal type | ||
+ | Low impedance loop antenna attachment | ||
+ | Practical use field-strength 300microvolts/m | ||
+ | The degree of 1 signal selection 40dB (±9kHz) | ||
+ | Image disturbance ratio 40dB | ||
+ | Signal to noise ratio 53dB | ||
+ | THD 0.5%(1kHz) | ||
+ | |||
Weitere Modelle der gleichen Serie: | Weitere Modelle der gleichen Serie: | ||
Revision as of 03:30, 7 April 2014
Daten
Allgemein
- Hersteller: Denon
- Modell: DRA-75 VR
- Baujahre: 1986-87
- Hergestellt in: Japan
- Farbe: schwarz
- Fernbedienung: ja, RC-75 (SUM-4x2)
- Leistungsaufnahme: 113W
- Abmessungen: 434 x 137 x 378 mm
- Gewicht: 8.9kg
- Neupreis ca.:
Anschlüsse
- Anzahl der Eingänge: 5
- Phono MM: 2.5mV/47kohm
- Phono MC: 0.25mV/100 ohms
- CD, AUX, Video/Tape1, VCR/Tape2(PB):150mV /, 47kohm
- Anzahl der Ausgänge:
- Speaker: AorB:6-16ohm, A+B:12-16ohm
- Headphone: 80mW (8ohms), 8-400-ohm
Technische Daten
Verstärker
- Dauerleistung (bei Klirrfaktor)
- 8 Ohm: 65W+65W
- 4 Ohm:
- Dynamikleistung
- 8 Ohm: 95W+95W
- 4 Ohm:
- Gesamtklirrfaktor: 0.025%
- Dämpfungsfaktor:
- Frequenzgang: 5Hz - 40kHz
- Signalrauschabstand: Phono MM: 82dB, Phono MC: 62dB, Line: 98dB
- Stereokanaltrennung:
- Klangregelung:
- Bass: ±8dB (100Hz)
- Höhen: ±8dB (10kHz)
- Loudness: 50Hz:+10dB, 10kHz:+5dB
- High Filter:
- Low Filter (Subsonic):
- Mute:
- Direct/Line-Straight:
Tuner
- Empfang: FM/AM
- Frequenzen:
- UKW: 76MHz - 90MHz
- AM: 522kHz - 1629kHz
- Frequenzgang: 20Hz-15kHz+0.2 -0.5 dB
- Eingangsmpfindlichkeit:
- Klirrfaktor: mono:0.07%, stereo:0.12%
- Signalrauschabstand: mono:82dB, stereo:80dB
- Kanaltrennung:
- Trennschärfe:
- Gleichwellenselektion:
- Nebenwellenselektion:
- Spiegelfrequenzdämpfung:
- ZF-Dämpfung:
- AM-Unterdrückung:
- Ausgangspegel:
- RDS:
- Stationsspeicher:
Besondere Ausstattungen
- Terminal Video-In, VCR-In/Out, Monitor-Out
Bemerkungen
AV receiver <Power amplifier part> Output power (20Hz - 20kHz) 65W+65W (8ohms) Practical use maximum except take-off (EIAJ) 95W+95W (8ohms) 110W+110W (6ohms) Input sensitivity/impedance CD input: 150mV(a maximum of 10V) /47kohm THD 0.0095% (20Hz - 20kHz, 32.5W, 8ohm) Cross modulation distortion 0.025% (an equivalent for 65W, 8ohms) Dynamic power 175W (2ohms) Output bandwidth 5Hz - 40kHz (Output 32.5W, 0.05%, 8ohms) Line-in frequency response 20Hz-50kHz±1.5dB (1W, 8ohm) Output load impedance 0.1ohm or less Output terminal Speaker: AorB:6-16ohm, A+B:12-16ohm Headset-jack maximum except take-off: 80mW (8ohms), 8-400-ohm conformity <Preamplifier part> Input sensitivity/impedance Phono MM: 2.5mV/47kohm Phono MC: 0.25mV/100 ohms CD, AUX, Video/Tape1, VCR/Tape2(PB):150mV /, 47kohm The maximum except take-off/Output power 10V/150mV (Rec Out, Processor Loop Out) RIAA deflection 20Hz-20kHz±0.5dB (MM IN-Rec Out & Processor Loop Out) Signal to noise ratio (an input short circuit, the auditory sensation weighting A) Phono MM: 82dB (at the time of a 2.5mV input) Phono MC: 62dB (at the time of a 0.25mV input) Line: 98dB (at the time of a 150mV input) Tone control characteristic Bass: ±8dB (100Hz) Treble: ±8dB (10kHz) Loudness characteristic (A continuation variable, maximum) 50Hz:+10dB 10kHz:+5dB <Image part> Terminal Video-In, VCR-In/Out, Monitor-Out Rated voltage/impedance 1 Vp-p/75ohms (input and output) <FM tuner part> Received frequency 76MHz - 90MHz Intermediate frequency 10.7MHz Antenna terminal 300ohms of coaxial 75ohm& terminal type balance Practical speed 9.3dBf Signal to noise ratio sensitivity of 50dB stereo:36.5dBf mono:13.5dBf The degree of effective selection 60dB (±400kHz) Capture ratio 1.2dB IF disturbance ratio 70dB Image disturbance ratio 40dB AM oppression ratio 60dB Frequency response 20Hz-15kHz+0.2 -0.5 dB Auditory-sensation-weighting signal to noise ratio mono:82dB stereo:80dB THD (1kHz) mono:0.07% stereo:0.12% Degree of separation 48dB(1kHz) <AM tuner part> Received frequency 522kHz - 1629kHz Intermediate frequency 450kHz Antenna terminal Terminal type Low impedance loop antenna attachment Practical use field-strength 300microvolts/m The degree of 1 signal selection 40dB (±9kHz) Image disturbance ratio 40dB Signal to noise ratio 53dB THD 0.5%(1kHz)
Weitere Modelle der gleichen Serie:
Bilder