Editing Wangine WPA-120

Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.

The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision Your text
Line 1: Line 1:
== Data ==
+
== Daten ==
{{navigation}}
+
{{Navigation}}
'''General'''
+
'''Allgemein'''
* Manufacturer: [[Wangine]]
+
* Hersteller: [[Wangine]]
* Model: WPA 120
+
* Modell: WPA 120
* Color: Silver
+
* Farbe: Silber
* Type: Stereo  
+
* Typ: Stereo  
* Power consumption: max 800 watts
+
* Leistungsaufnahme: max 800 Watt
* Dimensions: 422x140x318mm (WxHxD)
+
* Abmessungen: 422x140x318mm (BxHxT)
* Weight: 16,3 kg
+
* Gewicht: 16,3 kg
* Original price: 789 DM (October 1983)
+
* Neupreis: 789 DM (Oktober 1983)
  
  
'''Technical data'''
+
'''Technische Daten'''
* Continuous power
+
* Dauerleistung
8 Ohm: 2x120W
+
** 8 Ohm: 2x120W
* dynamic power
+
* Dynamikleistung
** 8 Ohm: 2x240W
+
** 8 Ohm: 2 x 400W
* Distortion factor
+
* Klirrfaktor
** Total Harmonic Distortion <0,015% at rated power output 8 Ohm
+
** Total Harmonic Distortion <0,015% at rated power output 8 Ohm
Inter Modulation Distortion &lt;0,009% at rated power output 8 Ohm
+
** Inter Modulation Distortion <0,009% at rated power output 8 Ohm
* Attenuation Factor: 200 (8 ohms, 1,000 Hz)
+
* Dämpfungsfaktor: 200 (8 Ohm, 1.000 Hz)
S/N Ratio: 110dB (IHF, A-weighted)
+
* S/N Ratio: 110dB (IHF, A-weighted)
* Frequency range: 5Hz - 200,000 Hz (+0, -3 dB)
+
* Frequenzbereich: 5Hz - 200.000 Hz (+0, -3 dB)
* Input impedance: 50 kOhm
+
* Eingangsimpedanz: 50 kOhm
* Input sensitivity: 1 Volt
+
* Eingangsempfindlichkeit: 1 Volt
 
* Output: 4 - 16 Ohm
 
* Output: 4 - 16 Ohm
  
  
'''Other'''
+
'''Sonstiges'''
 
* Spectrum Analyzer
 
* Spectrum Analyzer
32 Hz
+
** 32 Hz
 
** 63 Hz
 
** 63 Hz
 
** 125 Hz
 
** 125 Hz
 
** 250 Hz
 
** 250 Hz
500 Hz
+
** 500 Hz
 
** 1 kHz
 
** 1 kHz
 
** 2 kHz
 
** 2 kHz
Line 40: Line 40:
 
** 8 kHz
 
** 8 kHz
 
** 16 kHz
 
** 16 kHz
* Display switching
+
* Anzeige-Umschaltung
** 1 =&gt; 1 Watts to 240 Watts
+
** 1 => 1 Watts to 240 Watts
** 0.1 =&gt; 0.1 Watts to 24 Watts
+
** 0,1 => 0,1 Watts to 24 Watts
** 0.01 =&gt; 0.01 Watts to 2.4 Watts
+
** 0,01 => 0,01 Watts to 2,4 Watts
 
* Control Switch
 
* Control Switch
 
** A, B, A+B
 
** A, B, A+B
  
  
'''Semiconductor'''
+
'''Halbleiter'''
 
* 2 FET
 
* 2 FET
 
* 10 IC
 
* 10 IC
* 71 transistors
+
* 71 Transistors
 
* 91 LEDs
 
* 91 LEDs
* 46 diodes
+
* 46 Dioden
* 3 bridge rectifier
+
* 3 Brückengleichrichter
  
  
'''Note'''
+
'''Bemerkung'''
  
The above performance data are original data.
+
Die o.g. Leistungsdaten sind original Angaben.
Own measured power at 50 Hz sine input signal:
+
Eigene gemessene Leistungen bei 50 Hz Sinus Eingangs-Signal:
  
~ 145 W into 8 Ohm
+
~ 145 W an 8 Ohm
  
~ 225 W into 4 Ohm
+
~ 225 W an 4 Ohm
  
Measured at an appropriate load resistor with optical control by oscilloscopes for a 'clean' output signal. Only one channel was measured under power. Because of the construction as a double mono power amplifier (separate power supplies) this power should be reached on both power amplifiers at the same time.
+
Gemessen wurde an einem entsprechendem Lastwiederstand mit optischer Kontrolle per Oszilloskopen auf ein 'sauberes' Ausgangssignal. Es wurde auch nur ein Kanal unter Leistung gemessen. Durch die Bauweise als Doppel-Mono-Endstufe (getrennte Netzteile) dürften diese Leistungen auch auf beide Endstufen zugleich erreicht werden.
Whether this power represents a continuous power was not checked, but these powers were reached cleanly over a period of about 15 minutes. After that, the measurement was stopped to protect the load resistors, as they were not sufficiently dimensioned in terms of power.
+
Ob Diese Leistung eine Dauerleistung darstellt, wurde nicht überprüft, jedoch wurden diese Leistungen über einem Zeitraum von etwa 15 Minuten sauber erreicht. Danach wurde die Messung zur Schonung der Lastwiderstände abgebrochen, da diese leistungsmäßig nicht ausreichend dimensioniert waren.
  
  
The output stage has a switch-on delay and a protection circuit. This protective circuit is partially sensitive to mains interference. A sufficiently dimensioned mains filter can remedy this.
+
Die Endstufe besitzt eine Einschaltverzögerung und eine Schutzschaltung. Diese Schutzschaltung reagiert teilweise empfindlich auf Netzstörungen. Ein ausreichend dimensionierter Netzfilter schafft hier Abhilfe.
  
== Remarks ==
+
== Bemerkungen ==
Other models of the same series:
+
Weitere Modelle der gleichen Serie:
 
* [[Wangine WTA-120|WTA-120]]
 
* [[Wangine WTA-120|WTA-120]]
 
* [[Wangine WEQ-120|WEQ-120]]
 
* [[Wangine WEQ-120|WEQ-120]]
  
== Pictures ==
+
== Bilder ==
[[Image:Wangine_WPA120_01.jpg]]
+
[[Bild:Wangine_WPA120_01.jpg]]
  
[[Image:Wangine_WPA120_02.jpg]]
+
[[Bild:Wangine_WPA120_02.jpg]]
  
[[Image:Wangine_WPA120_03.jpg]]
+
[[Bild:Wangine_WPA120_03.jpg]]
  
[[Image:Wangine_WPA120_04.jpg]]
+
[[Bild:Wangine_WPA120_04.jpg]]
  
[[Image:Wangine_WPA120_05.jpg]]
+
[[Bild:Wangine_WPA120_05.jpg]]
  
  
[[Category:Power Amplifiers]]
+
[[Kategorie:Endstufen]]

Please note that all contributions to hifi-wiki.com may be edited, altered, or removed by other contributors. If you do not want your writing to be edited mercilessly, then do not submit it here.
You are also promising us that you wrote this yourself, or copied it from a public domain or similar free resource (see hifi-wiki.com:Copyrights for details). Do not submit copyrighted work without permission!

To edit this page, please answer the question that appears below (more info):

Cancel Editing help (opens in new window)

Template used on this page: